The CAT28C16AXI-90T belongs to the category of non-volatile memory devices.
This product is primarily used for storing and retrieving digital information in electronic systems.
The CAT28C16AXI-90T is available in an Axial Lead package.
The essence of this product lies in its ability to provide reliable and non-volatile storage for electronic systems.
The CAT28C16AXI-90T is typically packaged in reels or tubes, with quantities varying based on customer requirements.
The CAT28C16AXI-90T has a total of 28 pins, each serving a specific function. Here is a detailed pin configuration:
The CAT28C16AXI-90T is based on EEPROM technology, which allows for electrically erasing and reprogramming of data. It utilizes a grid of memory cells that can be individually addressed and modified. When data is written to the device, it is stored in the memory cells using electrical charges. These charges are retained even when power is removed, ensuring non-volatile storage.
The CAT28C16AXI-90T finds applications in various electronic systems, including but not limited to: - Embedded systems - Automotive electronics - Industrial control systems - Consumer electronics - Medical devices
In embedded systems, it can be used for storing firmware, configuration data, or user settings. In automotive electronics, it can store critical information such as calibration data or vehicle parameters. Industrial control systems can utilize this memory for storing program code or system configurations. In consumer electronics, it can be used for data storage in devices like smartwatches or digital cameras. Medical devices can benefit from the CAT28C16AXI-90T for storing patient data or device settings.
Sure! Here are 10 common questions and answers related to the application of CAT28C16AXI-90T in technical solutions:
Q: What is CAT28C16AXI-90T? A: CAT28C16AXI-90T is a specific model of EEPROM (Electrically Erasable Programmable Read-Only Memory) chip.
Q: What is the capacity of CAT28C16AXI-90T? A: CAT28C16AXI-90T has a capacity of 16 kilobits, which is equivalent to 2 kilobytes.
Q: What is the operating voltage range for CAT28C16AXI-90T? A: The operating voltage range for CAT28C16AXI-90T is typically between 4.5V and 5.5V.
Q: What is the maximum clock frequency supported by CAT28C16AXI-90T? A: CAT28C16AXI-90T supports a maximum clock frequency of 90 MHz.
Q: Can CAT28C16AXI-90T be used for storing program code? A: Yes, CAT28C16AXI-90T can be used for storing program code, as well as other non-volatile data.
Q: Is CAT28C16AXI-90T compatible with standard microcontrollers? A: Yes, CAT28C16AXI-90T is designed to be compatible with standard microcontrollers and can be easily interfaced with them.
Q: Does CAT28C16AXI-90T support hardware write protection? A: Yes, CAT28C16AXI-90T provides hardware write protection features to prevent accidental or unauthorized writes.
Q: What is the endurance rating of CAT28C16AXI-90T? A: CAT28C16AXI-90T has an endurance rating of at least 1 million write cycles.
Q: Can CAT28C16AXI-90T operate in harsh environments? A: Yes, CAT28C16AXI-90T is designed to operate reliably in a wide temperature range and can withstand harsh environmental conditions.
Q: Are there any specific programming requirements for CAT28C16AXI-90T? A: CAT28C16AXI-90T requires a specific programming voltage and timing sequence, which should be followed as per the datasheet provided by the manufacturer.
Please note that these answers are general and may vary depending on the specific application and requirements. It is always recommended to refer to the datasheet and consult with the manufacturer for accurate and detailed information.